Warning
Sense is connected to dangerous voltages. Improper use or installation can be dangerous or even fatal. Please make sure to follow these guidelines:
1. The installation should be conducted by a qualified professional, according to local electrical codes.
2. Personal protective equipment should be worn when installing a current sensor on a conductor exposing hazardous live voltages. If the current sensors are used in a manner other than specified, the safety protection provided may be impaired.
3. Do not try to open the Sense monitor, touch any internal parts, or try to repair it.
4. If you believe the monitor, sensors, or cables may have been damaged, do not try to use them.
5. Use the Sense monitor only in the United States and Canada, and only with a 60Hz 120V/240V split phase system.
6. Install the Sense monitor where it will not be exposed to direct sunlight or extremely low or high temperatures. No exposure to water. RH < 90%; Elevation < 2,000 meters; Temperature 0 – 68°C.
Specifications
Technical Specifications
Sense is a home energy monitoring device. It is used to measure the current and voltage on the service mains. It monitors two phases of 110/120VAC. If installed outside, it must be kept dry and within specified temperature ranges.
Current Sensor Specifications
CAT IV 250V 200A max
Cable length: 46” | Inside diameter: 0.95”
May be used on uninsulated conductors
Monitor Specifications
Compatibility: 120VAC (90V-130V)
Power Use: < 5 Watts, 0.1 amps
Wi-Fi: 2.4 GHz 802.11b/g/n
Size: 137mm x 66mm x 32mm
Weight: 200g
Climate Specifications
RH <90%; IPx0 rating
Temperature: 32 – 154.4ºF (0-68ºC)
Elevation < 6,561 ft (<2,000m)
Legal
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to these conditions:
1. It may not cause harmful interference.
2. It must accept any interference received, including interference that may cause undesired operation. If it is not installed and used as per the instructions, it may cause interference which is harmful to wireless communications. There is no guarantee that interference will not occur in a particular installation. If it does cause interference we recommend: reorienting or relocating the receiving antenna, or increasing the separation between the device and the receiver.
3. Patents: sense.com/patents
Certified to CSA STD C22.2 No. 61010-1
Conforms to UL STD 2808
Conforms to UL STD 61010-1
Conforms to UL STD 61010-2-032
Conforms to CAN ICES-3(B)/NMB-3(B)